Who is this article for?

Users responsible for maintaining hardware.

No special access or permissions are required.

This article walks you through the process of installing a replacement modem for the visitor terminal.

1. Preparation

You will need the following components and tools to complete this installation:

• Camera and bracket

• Phillips Head Screwdriver

• Snips (wire cutters)

• Zip ties

2. Installation

To install the camera:

1. Unplug the USB camera from the terminal and carefully cut the zip ties holding the cables.

2. Unscrew the screw holding the bracket, then slide the camera and bracket out.

3. Slide the replacement camera and bracket into the slot and screw it back in.

4. Connect the USB cable back into the available USB port.

5. Zip tie the cable to the bracket, leaving some slack to avoid strain.

6. Tuck the remaining cable neatly inside the stand.

3. Returning components

Please arrange to return replaced components to:

Damstra Technology
Unit 3/74 Mustang Drive, 
Rutherford NSW, 2320
Ph: 1300 722 801

You may use the original packaging and box that the replacement components were sent in for returning the unit.